This repair system can be used with most glue down engineered wood floors, as long as the adhesive is completely cured. If the original adhesive used for installation was not DriTac, test a sample area for compatibility.Do not use DriTac Wood Floor Repair Kit to repair solid wood flooring.

Kit Includes:

• 1-1 32 oz of DriTac Repair Adhesive
• 1-60cc Plastic Syringe
• 2-Metal Applicators
• 2- Drill Bits
• 8-Dowels
• 1-Dowel Punch

DriTac Wood Floor Repair Kit

DriTac Adhesive Group has developed a system to repair the hollow spots and popping conditions for solid wood and bamboo flooring installations. From the same company that introduced the most popular wood flooring repair kit on the market today, the DriTac Wood Floor Repair Kit for engineered wood flooring, comes a new repair kit for use with solid wood and bamboo floors. . These defects cost the flooring industry millions of dollars per year. Studies and experience show that the major cause of problems for wood flooring installations are voids between the flooring and the subfloor.

After years and years of successful repairs with our DriTac Wood Floor Repair Kit for engineered wood flooring and constant requests from installers to design a repair kit for solid wood and bamboo floors, DriTac is here to once again fix the problem and provide the solution for voids, hollow spots and popping conditions in wood flooring installations!

Kit Includes:

• 1 - Injection Gun
• 2 - Adhesive Cartridges
• 3 - Mixing Nozzles
• 3 - Metal Applicator Tips
• 2 - Drill Bits
• 4 - Wood Dowels
• 1 - Dowel Punch

DriTac Solid Wood & Bamboo Floor Repair Kit

DriTac Solid Wood & Bamboo Floor Repair System

Instructions:

Place the dual component cartridge kit in a dual plunger manual
dispensing gun and remove the end cap from the cartridge. Attach a
static mixer nozzle to the cartridge. Keep cartridge upright until use.
Bleed off any air inside the cartridge by keeping the mixer nozzle upward
and slightly squeezing handle. Dispense the material by working the
trigger of the gun. Dispense and properly dispose of a small amount of
material to start the material mixing. This is done to ensure
complete product mix.

Proceed with application. To stop dispensing, release pressure by
pressing the lever on the gun and pulling back the plungers. When
application is complete, remove static mixer and dispose of all items properly

Kit Includes:

• 3- Adhesive Cartridges
• 4- Mixing Nozzles
• 4- Applicator Tips
• 2- Wood Dowels
• 2- Drill Bits

DriTac Solid Wood & Bamboo Floor Repair System